@[email protected] to [email protected]English • edit-24 months agoFriendly reminder to print awkward models on an angleaussie.zoneimagemessage-square21fedilinkarrow-up1169
arrow-up1169imageFriendly reminder to print awkward models on an angleaussie.zone@[email protected] to [email protected]English • edit-24 months agomessage-square21fedilink
This is a battery cell case that was a pain last time I printed it with supports Model: https://www.thingiverse.com/thing:5240533/files
minus-square@[email protected]linkfedilinkEnglish17•4 months agoOhh nice, battery pez dispenser! Is that considered a raft + supports or just supports on there?
minus-square@[email protected]linkfedilinkEnglish2•4 months agoLooks like the model is just resting on supports. Might have a roof or “support interface” (a layer between supports and model)
minus-square@[email protected]OPlinkfedilinkEnglish8•4 months agoJust supports, I had to manually paint them in to prevent the slicer from putting them all the way up the side
minus-square@[email protected]linkfedilinkEnglish7•4 months agoIn Orca slicer, if you use tree supports and hybrid, an option appears (advanced must be enabled) for something like “Essential supports only”. It is so much better than spending all that time adding or blocking supports.
minus-squareanguolinkfedilinkEnglish1•4 months agoWould that be equivalent to PrusaSlicer’s “automatic painting”?
minus-square@[email protected]linkfedilinkEnglish1•4 months agoI have no clue about that. I only recently stumbled across the orca setting while waging my own battle against excessively aggressive supports.
Ohh nice, battery pez dispenser!
Is that considered a raft + supports or just supports on there?
Looks like the model is just resting on supports. Might have a roof or “support interface” (a layer between supports and model)
Just supports, I had to manually paint them in to prevent the slicer from putting them all the way up the side
In Orca slicer, if you use tree supports and hybrid, an option appears (advanced must be enabled) for something like “Essential supports only”. It is so much better than spending all that time adding or blocking supports.
Would that be equivalent to PrusaSlicer’s “automatic painting”?
I have no clue about that. I only recently stumbled across the orca setting while waging my own battle against excessively aggressive supports.
Ooh thanks I’ll give that a try